Mitchell 340 anti reverse assembly

Discussions on How to Service Your Mitchell Reel and more...
Post Reply
User avatar
Jimntenn
Posts: 1
Joined: Wed Mar 16, 2022 12:04 am

Mitchell 340 anti reverse assembly

Post by Jimntenn »

:oops: l have a new-to- me Mitchell 340 reel which I took apart to clean and lubricate. The anti reverse spring & lever piped out and I do not know how to reassemble them. There is not much information about the 340 reel.
New Member who needs help!!!!
Jimntenn


User avatar
Schrack
Posts: 227
Joined: Tue Jun 15, 2021 3:35 am
Location: Dover, Delawhere?

Re: Mitchell 340 anti reverse assembly

Post by Schrack »

Welcome to the Forum.
I looked at a schematic and would assume it has 2 parts, actual Dog 81181 and spring 81188.
The dog goes on the small pin on case, then you position the spring from case to dog.
When you move the lever on out side of case it moves the drag off of the teeth on drive gear.
The spring puts pressure on dog to hold it down in anti reverse position.
I d not have a 340, but from repairing other models the dog reverse configuration is basically the same.
I can not accurately tell you exactly how it goes.
Hope this helps. Regards, Schrack


User avatar
allansharkey
Posts: 41
Joined: Wed Jul 21, 2021 7:06 am
Location: UK

Re: Mitchell 340 anti reverse assembly

Post by allansharkey »

Hi, I always found schematics gave me a a idea how and where the pats fit in relationship to other parts which helped visually, unfortunately some moron wrecked this site that held schematics and other helpful things, try googling for a schematic for your reel, hope this helps.


Post Reply