Mitchell Reel Museum - Mitchell Mates Discussion Group
http://mitchellreelmuseum.com/forum/

Parts Needed - 908 or 308a
http://mitchellreelmuseum.com/forum/viewtopic.php?f=78&t=6032
Page 1 of 1

Author:  Balvar24 [ Wed Mar 13, 2019 9:29 am ]
Post subject:  Parts Needed - 908 or 308a

I need a main drive gear for a 908. I believe that the 308a gear is the same.

Thanks.

Author:  cshannon772 [ Wed Mar 13, 2019 10:18 pm ]
Post subject:  Re: Parts Needed - 908 or 308a

Hello Balvar24Welcome to the Mitchell Museum :sSig_welcome2:

You are looking for part number 82793 and you are correct that it is the same gear that goes in the 308A. Unfortunately, I don't have one of these gears but you may have some luck looking on eBay - there are a few very reliable Mitchell parts sellers on there who may be able to help you out.

Regards,
Chris

Author:  Balvar24 [ Thu Mar 14, 2019 9:33 am ]
Post subject:  Re: Parts Needed - 908 or 308a

That'd be the part.

I've been watching for a gear to come up.

In the mean time, I'm going to try to use some 2-part industrial epoxy (sounds better than JB Weld) to remedy my issue, albeit probably a temporary fix.

Author:  Ted Lanham [ Thu Mar 14, 2019 2:37 pm ]
Post subject:  Re: Parts Needed - 908 or 308a

Balvar24,
I thought these were brass, but I got this one out of a 308A.
Does this look right?
Ted Lanham

Author:  Balvar24 [ Thu Mar 14, 2019 8:07 pm ]
Post subject:  Re: Parts Needed - 908 or 308a

The one that I have is brass. Curious. The parts schematics list the same part numbers for each reel.

Author:  Ted Lanham [ Thu Mar 14, 2019 8:15 pm ]
Post subject:  Re: Parts Needed - 908 or 308a

Balvar24,
I did a search on the web after I posted this picture, and found some of brass and some of aluminum. :sCo_hmmthink:

Ted Lanham

Author:  Balvar24 [ Thu Mar 14, 2019 9:58 pm ]
Post subject:  Re: Parts Needed - 908 or 308a

Interesting, indeed.

Author:  Ted Lanham [ Fri Mar 15, 2019 8:05 am ]
Post subject:  Re: Parts Needed - 908 or 308a

Balvar24,
Well, if you decide that this one will work, I can make it happen.
Ted

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/