Mitchell Reel Museum - Mitchell Mates Discussion Group

Mitchell 300 excellence clutch
Page 1 of 1

Author:  Ssannella [ Tue Jun 18, 2019 9:16 am ]
Post subject:  Mitchell 300 excellence clutch

I took my mitchell 300 excellence reel apart to oil it up and did not take a picture of the way the clutch is laid out. I did not unscrew part 85032 and the spring but then after i took out 85116 and 85127, i could not figure out how they go back and relate to each other. Does anyone have a picture of an assembled one? The schematics i i see online simply are not clear on how tese two parts relate. Thanks for any comments. if anyone has anpicture of an assembled reel showing the correct layout. Thanks again.

Author:  Ted Lanham [ Tue Jun 18, 2019 4:13 pm ]
Post subject:  Re: Mitchell 300 excellence clutch

Greetings Ssannella

Welcome to the Mitchell Reel Museum.
I have to suggest that you might want to edit out your email address. There are people that would spread that kind of info around. You can exchange email addresses safer by PM mail.

Ted Lanham

Author:  Ssannella [ Wed Jun 19, 2019 7:05 am ]
Post subject:  Re: Mitchell 300 excellence clutch

Ed, you are probably correct. It appears i cann ot edit it. Can you delete it, and i will start over? Thanks.

Author:  Ted Lanham [ Wed Jun 19, 2019 7:57 am ]
Post subject:  Re: Mitchell 300 excellence clutch

I took it out for you.

Mates, If you can help Steve with his 300 Excellence, send him an PM.


Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group