Mitchell Reel Museum - Mitchell Mates Discussion Group
http://mitchellreelmuseum.com/forum/

402 gear setting on reassembly
http://mitchellreelmuseum.com/forum/viewtopic.php?f=75&t=6144
Page 1 of 1

Author:  dennisK [ Mon Jun 10, 2019 3:40 pm ]
Post subject:  402 gear setting on reassembly

Can someone help me with the orientation of the plasmatic gear and cam ring and main gear when reassembling the reel? I am trying to find reference points that enable the reel to turn smoothly. When I try to reassemble the reel, it does not complete a full rotations before is tops or bottoms out these stopping the rotation. Your help will be greatly appreciated - Thank you

Author:  Oscillator1 [ Mon Jun 10, 2019 4:07 pm ]
Post subject:  Re: 402 gear setting on reassembly

Hello Dennis, First let me :sSig_welcome4: you to the Mitchell Reel Museum. If you go to the schematics section and find the breakdown of your reel you may find the solution to your problem , it's not very complicated. If not I'm sure one of the other Mates will give you more advice. Best regards, John in Pa. :sCh_fisherman:

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/