Mitchell Reel Museum - Mitchell Mates Discussion Group
http://mitchellreelmuseum.com/forum/

Looking For: 1956 Mitchell 300 Spool Pawl/Pawl Spring
http://mitchellreelmuseum.com/forum/viewtopic.php?f=75&t=5766
Page 1 of 1

Author:  Moses1986 [ Wed Jun 06, 2018 3:34 pm ]
Post subject:  Looking For: 1956 Mitchell 300 Spool Pawl/Pawl Spring

Trying to service my 1956 Mitchell 300, but the Spool is missing the Pawl spring, and the actual Pawl itself is rusty. I am ok with cleaning off the corrosion and just reusing the Pawl I have but what do I do for the missing spring? Another solution would be just to get a new spool that already has the setup, but all the spools I see out there look different than what my reel can use.

Part No. on the 1956 Mitchell 300 Schematic are 18a and 38a, any help or suggestions would be very helpful:)

http://tinypic.com/r/5v0tnt/9
http://tinypic.com/r/bdqzo3/9
http://tinypic.com/r/2dln85j/9

Author:  Ted Lanham [ Thu Jun 07, 2018 2:23 pm ]
Post subject:  Re: Looking For: 1956 Mitchell 300 Spool Pawl/Pawl Spring

Moses1986,
I have the parts you are asking about, I believe. Send me your full address, via PM mail, and I'll send them to you.

Ted Lanham

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/