|Mitchell Reel Museum - Mitchell Mates Discussion Group
|GM 303 HELP....
|Page 1 of 1|
|Author:||piscesman [ Mon Mar 09, 2015 8:05 pm ]|
|Post subject:||GM 303 HELP....|
Well I rec'd my new main bearing and put it in. Sounds much smoother than one took out. For some reason the whole thing jams up when rotor is installed and tightened down. The shim is over the bearing and a plastic slotted washer so to speak per schematics. Any help on repair??? I have service manuals that show I put things back in order. Anything else I overlooked?? Thanks for any help.......
|Author:||piscesman [ Fri Mar 13, 2015 6:40 am ]|
|Post subject:||Re: GM 303 HELP....|
Well as luck would have it ( good ) I was able to solve the problem. Seems I didn't push the bearing in all the way so the locking crews are on top securing the bearing. All serviced and ready for those salt water fish. Runs pretty smooth so my wife should be happy using it................
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group